Re: The Colorado BS thread
I appear to have a bit of a problem...lol... I went to pull the Schrader valve in my ori strut resevoir and rounded the Schrader when flats ...so tired a pair of vice grips but they slip off ... so I'm not 100% sure how to go about removing this F@#g valve ... My thoughts are to remove the top cap remove the valve stem and drill out the middle then collapse it and " it probably should cone out"... Any suggestions welcome since I've never had to think My way around getting something like this out. I'm not super concerned it's just if I break it replacing it could take awhile due to stock.
I appear to have a bit of a problem...lol... I went to pull the Schrader valve in my ori strut resevoir and rounded the Schrader when flats ...so tired a pair of vice grips but they slip off ... so I'm not 100% sure how to go about removing this F@#g valve ... My thoughts are to remove the top cap remove the valve stem and drill out the middle then collapse it and " it probably should cone out"... Any suggestions welcome since I've never had to think My way around getting something like this out. I'm not super concerned it's just if I break it replacing it could take awhile due to stock.