I just did my left outer and right inner tie rod ends (on the same tie rod).
I was careful to mark the tie rods, but when I put the new ones on, my tracking is off. Specifically, one wheel is about 18 degrees off of straight when the other is straight.
I can not make either tie rod end go in any further.
What could I have done wrong?
How do I fix it?
Thank you.
I was careful to mark the tie rods, but when I put the new ones on, my tracking is off. Specifically, one wheel is about 18 degrees off of straight when the other is straight.
I can not make either tie rod end go in any further.
What could I have done wrong?
How do I fix it?
Thank you.