Search results

I did a quick solo run to Big Bear thru Crab Flats from Green Valley lake. I wanted to check trans temp with a different pancake trans cooler I installed behind the grill. I had the Deraile dbl stack with the electric fan and it was worthless where I had it. It was the only place I could fit, it...

Looking for a Dana 300 tcase aluminum front output cover and yoke support. I seen one on the web but do not know who makes it. I flipped my 300 a few years back and I cut fork mounts off . Years latter I've developed an annoying leak. Hope Novak or JB conversions does it or I am stuck.

Ford 9'' 4.10 ring and pinion. like new $50.00 Dana 60 rear 4.56 w/dana limited slip carrier.NEW $300.00 Conn Ferr roof rack w/lights & hi lift jack mounted $450.00 Bilstien shocks misc lengths $20.00 each Rancho stabalizers $20.00 3-5 on 4.5 stock steelies free Complete 85 XJ w/ 289 V/8 C-4...

Finally getting to my 3 link! After hours of research and thumb twirling I finally decided to ignore the most significant foundation of from the creation of man and the universe, NUMBERS! That's right mathematics! I am going with my gut feeling and numerous hours just laying under the ole girl...

:looney: This is how I feel after almost a year of reading putting it down and picking it up again! No one that I can find list or even talk about what % or numbers goal to shoot for! They all say make your links longer, spread them out on the axle farther, lower your roll center, raise your...

Four 245/75/17 Firestone A/T's that came of my pickup! Average tread left at 85% no patches or plugs all 4 for $120.00 call 951-906 three six 79 and I'll text pics of tread!

Ok so I've read :geek:a lot about 3-4 links and the criticism on radius arms but this is a pan hard bar question that I feel is narrowly touched on! I've read the angle should match the drag link angle! Then I've read it should be level! SO what is it! Mine is at the drag link angle and about...

I'm thinking of visiting Durango late September! I attended school at Ft. Lewis back in the 80's on a football scholarship! My coach was Barnett before he moved on! My son recently released from the Coast guard is considering attending there as well and wants to check out the town and campus. We...

I have a set of Goodyear wrangler 265-70-17 at's for free. The worst one is at about 30% the other are 40%. I acquired them for whom ever could use them, I can not use them, I need 16"s. Call 951 906-3679 I have other singles Ineed to see the sizes!

Ok I saw the post on the kick down by Indamiddle77. I read it and I am some what confused on the directions since one guy was talking about a Mopar trans but INDA had a AW4. I also read the post by Tayln regarding kick down adjustment for an AW4. So if that can be clarified for me to do IF that...

Anyone have complaints from any electronic replacement parts from Rock Auto, such as Throttle Position Sensor (mainly what I need), or CPS like parts?? O'Reileys sucks in this category, just as well, the water pump lasted less than 1 year (9 months). The w/p is warranted but who wants to replace...

Need to figure out the plus minus of square versus tube radius arms! Any comments?

I need a descent 1999 2WD auto trans but will accept a 4x4 with or without 231 t-case! I will convert it to 4x4 if I cannot find a 2WD version, I have a t-case and front axle so I can go either way!

I have tried several times to search for any post on a 4.3 liter S10/Bravada engine swap and have had no success. I find it hard to believe that no one has done this! If anyone knows of any post please forward them to me. I am going to remove the Boss motor I have in my 1985 XJ. I cannot smog it...

Quick to the point info: 1999 AW4 XJ 2wd not shifting into O.D. trans exchanged out at about 190k for a salvage with under 100k donor. Trans works fine for over 1 year then it threw a code. Code: PO700 but also recent PO123 TPS which I will replace after the trans fix if it does not clear. The...

Last night the wife was driving my son's 99 jeep. She was trying to get it ready for him when he comes home on leave. She was doing frwy speeds and she said it lost power. No noise nothing. She stepped on throtle but it did not respond. She tried to start it, it turns but won't light. I had...

I finally got off my A$$ and built a double swing arm rear bumper! The left carries my spare that was getting slammed under the rear of the van on mild inclines! I made the ladder to access my roof rack I built several years ago! The ladder swings down and cradles the tire for easy lifting and...

Finally decided on going coil over but do not know much about them being old school and all! I found a brand new set of 10" Fox air shocks and I'm wondering if that might work also. I can get swayaway's for $315 10" travel apiece at 2.0 but I'm not sure if I should go with 2.5's and more travel...

I was looking at some of the past post regarding locations to wheel and explore but I haven't seen anything about Garlock or Randsburg! I went there a few years back and really enjoyed it. They have host cabins (some are shanties) you can stay in but they are a 1st come 1st serve. There are some...

I have an opportunity to purchase a 89/90? Renix and would like to know block wise if I can use this for a stroker to put in my 95 H.O. XJ? I know much externally is different, but is the block and or the head interchangeable? I would assume the head may not be due to valving or fuel rails, but...