Recent content by xjpio

What order does the clutch plates go in? It is out of a dana 35. The carrier split in two and when I removed it, the clutch pack dropped out and now I don't know the proper order. Thanks

For peoples info there is the following site with some info on doing a 2.8L to 4.0L engine swap: http://members.shaw.ca/Jeep.XJ/content/engine/prep.htm

automatic

Is this a direct swap? Thx

Can the input gear from the np229 be swapped into the np207? I have np207 transfer case that has 21 splines but I need a 23 spline input gear to fit it to a torqueflite 904 transmission in an 86 2.8 Cherokee.

YELLAHEEP, Could you please forward me the write up you prepared on doing a 4.3L swap? Thanks

Photos at the following link: http://ca.pg.photos.yahoo.com/ph/[email protected]/album?.dir=/a679 It is a 1986 Jeep Cherokee.

Do anyone know how to torque the low reverse band to 72 inch-lbs on the torqueflite 904 transmission when the adjusting screw is over the piston not the band? When adjusting the screw it keeps going in until the lock nut cannot be put on.

Can u swap a 904 two wheel drive transmission for a 904 four wheel transmission? Thanks