Recent content by JUSTINFIXIN

i put connectors in the rear, but the front unplug just behind the kick panel, so i didnt need to. the screwdriver is to remove kickpanel.

i just replaced the booster and master with a non abs style from the same year and used the lines and fittings from my old stuff, but did have to cut and flare 2 of them. works great. 91 xj limited. 5 and 1/2 inch lift, acos, 8.8, e locked, rock rails, corbue seats, tuffy console, removable...

i can now take my doors off and on with only a screwdriver. used to access my front power window connectors. if you dont have power window you wont need any tools. I will post some pics and stuff later on today.

It says the raffle is at grand center. were is that?

There is some around the hole you just cant see it in the picture!

Just make your own i did and mine sit a little lower than stock,I just took some inch square tubing made a square frame that bolts to the seat, then i took my old seat off the bracket put two pieces going across the bracket, then set my seat down on those as far as i could and still get a good...

Ok i still might need a skid plat but at least it will be higher, and hit on stuff alot less.and now the tank is out of the way so i can see my 8.8 rear swap alot better!

Heres some pics hope they help, i think this is a pretty slik way to get some more ground clearance. and as you can see all origanal parts were used, now i plan to cover it and use the space around it to put some military style storage boxes for tools and such.thanks for looking and all you...