Recent content by Fringeless

Link is dead, try this one https://web.archive.org/web/20130720082313/http://www.jeepsunlimited.com/forums/showthread.php?t=531598:piratefla:piratefla:piratefla:piratefla

I just installed megasquirt3 in my 92 cherokee stroked to 4.6. Just wondering if anyone can share an .msq to get this thing running. I am going to have it tuned eventually, but in the mean time, i need to get this thing on the road. I know jack about where to set timing and fuel etc.

I am in the process of doing a write up of an mS3 install to post here and on Jeep Strokers Forum. It is installed on a 92 running a 4.6 stroker @ 9.7:1 with stock trans, gauge and a/c function. However, I am I have run into an issue. Before I put in the MS3, my PLX devices gen 4 AFR module...

I am installing a transgo shift kit in my 92. My son lost the orings for the accumulators in the valve body. I cannot find an oring kit for them ANYwhere. Does anyone have a source or know the oring sizes?

Russ, sorry to hijack your thread with the engine management talk. Did you get the head installed yet? Would like to know your before and after impression.

My question exactly. Who does the flashing? Me, or someone else?

You dont take it off. The fitting is right behind the fan pulley. or underneath the ac compressor pulley.

Yes it gets to the bearing. It pushed grease out of the front and back.

Yes, you are correct. However, even though this particular bearing is a water pump bearing, it is not installed in a waterpump (it is the mechanical fan idler bearing- the water pump is separate on the 4.0 xj). Since the hole is placed for coolant egress, why not use it for grease ingress? When...

Thanks buddy.

I forgot to mention that I am making a homemade patch cable using a female connector from an old ecu and a male from an old harness. The splices are in a weatherproof box, not in the factory harness. What does this mean? It means that if my aftermarket ecu ever fails, then I unplug the...

For me it is about control. Basically, the Goldbox is the same thing as a megasquirt 3 pro. The only difference is that it is larger (room for addition of an internal transmission controller and it lacks an internal clock circuit). It and the ms3/ms3x/ms3pro are the only standalones that I...

anyone know how to move this to mod tech?

Dang it! I posted this in the wrong place.

While installing my ebay 200 amp alternator, I found out that my fan bearing was shot. I found a youtube vid of a guy who details the replacement. https://www.youtube.com/watch?v=6SQnw1lqYjs I ordered the bearing mentioned in the the vid for 14 bucks. When I received it, I noticed that it had...