Trailer brake

[gird123]

I have a small tent trailer with electric brakes, so i bought a brake controller and the 30 amp fuse. There are 4 wires. battery +, ground, brake lights, brake to trailer connector. I have searched and i could not find a good pic or info on where to tie the trailer connector under the dash.

I thought that since it already has the 7 pin connector it might have a plug under the dash?

 

[gird123]

it looks like this guy had the same question
http://www.naxja.org/forum/showthread.php?t=907068

i was hoping someone had a really clean install with pics

 

[ChiXJeff]

My 94 did not, I had to tie into the brake lead with a tap.

 

[gird123]

where did you tie in?

 

[gird123]

I know how to tie everything in except for the one that goes back to the connector. Any one know where that is under the dash?

 

[ChiXJeff]

where did you tie in?

I honestly don't remember. I installed it in 2001 and removed it 5 years later when I bought a tow rig.

 

[gird123]

thank you. I will keep looking

 

[gird123]

Ok so i finally figured it out. I'm slow. On the brake pedal the wire is white with a tan strip. I could not find the blue one so i finally followed it from the factory 7 pin connector. it ran by the drive side door and right up the wall to the dash and zip tied to the bundle of wires between the bundle and the fire wall was the blue wire with a tag that said brake controller! I looked for my camera and could not find it. Drug the tent trailer around the block and it works great.

Nate