Jeff in VA
<---respect
- Location
- Richmond, VA
Spent the morning replacing the thermostat housing, after three failed attempts at getting the old one to seal after I replaced the thermostat a few weeks ago. I didn't specifically ask for one, but the parts place gave me a high-flow housing, and it juuuusssstttt barely clears the idler pulley and belt. Doesn't leak either, like the old one (turns out it was a tiny bit warped after all :headpop: )
about 1/8" clearance on the idler pulley:
little more clearance underneath for the belt:
Jeff
about 1/8" clearance on the idler pulley:
little more clearance underneath for the belt:
Jeff