• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

SYE yoke hitting e-Brake cable?

AeroSync

NAXJA Forum User
Location
Miami, FL
Recently swapped out my NP242 in my 99 XJ for an NP231 and installed it along with an AA SYE kit and a front driveshaft.

I haven't seen anyone else with this issue but when I turn right the yoke hits the e brake cable.

I will try to relocate it around but was wondering if anyone else had this issue.

ja7u8upe.jpg
 
Yea I figured using zip ties which is what I am going to do just wanted to check if anyone had the same issue so it is all better now.

I know it is possible to install the crossmember backwards and it offsets the t-case to the driver side. Check that.

Now that you mentioned it I am second guessing myself. Wouldn't I have a driveline vibration? I am pretty sure the mount and the skid are on correctly but will double check on the weekend.
 
Your drive line should not move that much when taking a corner that it causes it to hit it. Check your motor mounts and trans mount as well as the cross member as mentioned above.
 
Yea I figured using zip ties which is what I am going to do just wanted to check if anyone had the same issue so it is all better now.



Now that you mentioned it I am second guessing myself. Wouldn't I have a driveline vibration? I am pretty sure the mount and the skid are on correctly but will double check on the weekend.
It might or might not cause a vibration but the t-case would be visibly offset to the driver's side. It could also bind up the shift linkage where it connects to the frame.
 
I will zip tie it. I was just checking if it was a common occurrence.

Motor mounts are brown dogs and it has a new transmission mount with the skid the correct way.

It's nice to have no vibes though. This should have been my first mod.
 
Back
Top