Renegade_Azzy
NAXJA Forum User
- Location
- Finleyville, PA
Is there a place that I can find sensor output values (like the temp sensor runs 200-300 ohms) and what sort of signal needs to go to the tach and speedo?
I am building up a test and calibration setup for my new gauge kits (thread on that here), and would like to be able to tell the things to sit dead center and be able to move a pot or 1 and run through the range of motion so I can not only test the cluster, but make sure the needles are in the right places.
I am building up a test and calibration setup for my new gauge kits (thread on that here), and would like to be able to tell the things to sit dead center and be able to move a pot or 1 and run through the range of motion so I can not only test the cluster, but make sure the needles are in the right places.