smokeyyank
NAXJA Forum User
- Location
- Littleton, Crawlarado
Howdy all,
Quick question. My passenger side rear lower quarter panel is completely rusted out. It goes up about 4 -6 inches with the largest part being closest to the wheel. The other day I was taping at it with a hammer to see how bad the rust was and it's pretty gnarly. I was going to do the cut and fold but since I don't have any metal to cut or fold what options do I have? The only thought was the just cut out the rust and maybe use a new piece on metal and weld it in with spot welds to simulate the fold up piece? Any advice is appreciated. Thanks
Quick question. My passenger side rear lower quarter panel is completely rusted out. It goes up about 4 -6 inches with the largest part being closest to the wheel. The other day I was taping at it with a hammer to see how bad the rust was and it's pretty gnarly. I was going to do the cut and fold but since I don't have any metal to cut or fold what options do I have? The only thought was the just cut out the rust and maybe use a new piece on metal and weld it in with spot welds to simulate the fold up piece? Any advice is appreciated. Thanks