rear axle shaft bolt pattern change

[unhitched]

I just purchased some yukon chomo for my jeep, the picture showed that it was drilled for 2 patterns but when the shaft got here it was only drilled for one, 5 on 4.5. the reason i bought these shafts was to convert to 5 on 5.5, i knoiw i should have asked but is there anywhere locally in the ie that can re drill them for me? i think it may be cheaper than shipping both ways but who knows...

thanks

nick

 

[souske]

Was there a disclaimer on the site that the photo was just a representation?
If not, they should cover it

 

[xDUMPTRUCKx]

CTM racing is where i work.

Thats no problem for us.

Shoot me a pm for details.

 

[souske]

If you can dream it, CTM can make it reality

 

[Jimmyrigd]

Currie will redrill them they are in corona now

 

[GrimmJeeper]

i would call them and say hey wtf

 

[xDUMPTRUCKx]

Currie will redrill them they are in corona now

Curries good friends of ours, and one.of our.distributers. Not.to mention they run our axles and u joints in competition.

 

[RWKHausSupply]

What application?
D44 are and should always be dual drilled
C825 are not chromoly so guessing its not that application? If if it was then you're correct only one pattern.

Currie is who I would contact for axle pattern redrill.

 

[Mike L]

The ability to redrill the axles depends on the OD of the flange. When you call and ask you should tell them the OD and then they can say if it is possible. Good luck.