jeepfreak1020
NAXJA Forum User
- Location
- Thornton
So I just picked up a new jeep super cheap and in great shape. Needed a little work though. Front axle work. Said it needed ball joints and would fix it. So i snagged it. Jeep pulls super hard to the right and gets a little death wobble at 50 and above. So today we pressed out the old ball joints and pressed in new ones. Went to drive it, still pulls hard and still wobbles. It could use new tires, as they are a little shot. Going to swap them with a buddy tomorrow and see what that changes. If it dosent change anything where should i go next? Steering box dosent have much slop. All tre seam ok. I've seen way worse. Trac bar I can't really tell to much. And then control arm bushing I can't tell eather. Really dont wana dump a lot into stock stuff as she gets built in march with 44s and 37s. So don't wana waste a lot of money. Just wana be able to drive it till then.
It's a 2000 with stock 30 8.25. Everything is stock on it. Auto tranny. 242 t case.
It's a 2000 with stock 30 8.25. Everything is stock on it. Auto tranny. 242 t case.