NTB: Ax15 External Slave Bellhousing

[NINETNINEXJ]

I need to buy a bellhousing for an external slave ax15. A bolt fell off inside mine and blew a hole in the side of the bellhousing. If anyone has one they are willing to sell that would be greatly appreciated as this is my dd. I'm hoping to get this replaced this weekend. I am located in Westminster and have cash.

Thanks,
Travis

 

[5-90]

I'm assuming, then, that you're not converting? If you are, be sure to get the front bearing retainer as well, or the conversion won't work (if you aren't, forget what I said. Sadly, I don't have a part to help you...)

 

[NINETNINEXJ]

No I'm not converting anything, my xj is a 99. I just need to replace the bellhousing since mine is pretty mangled.

 

[5-90]

No I'm not converting anything, my xj is a 99. I just need to replace the bellhousing since mine is pretty mangled.

Just wanted to make sure. I know of three conversions that didn't come off because the front bearing retainer wasn't swapped, and they couldn't figure out why they couldn't disengage the clutch.

NB: The NV3550 bellhousing should be the same as the AX-15e, but that will probably be even less available than the AX-15e bell.

Good luck!

 

[NINETNINEXJ]

Yeah I did the conversion on my 88 mj when I swapped in an ax15. If I can't find one at the junk yards this weekend i probably pulling it to put in the xj since its my dd.

Thanks

 

[NINETNINEXJ]

I found a bellhousing so mods can delete this thread.