KP60 and 14 bolt complete

[jeepfreak1020]

-89 Dana 60 front with brand new 5.38 and Spartan locker, 35 spline inner and outer shafts, brand new bearings in the hubs, plated and beefed up factory knuckles, crane high steer arms, behind the axle full hydro steering, with 3" single ended PSC ram, crane diff cover, full truss from C to C that was welded on slow and axle is straight as a pin, all new king pin bearings.
-14 bolt rear ribbed axle shaved to 13 bolt, brand new 5.38 with orb of traction spool, disk break conversation, crane 13 bolt cover, 4 link brackets set up for straight uppers triangulated lowers

Axles have yet to be ran, and come complete. Looking to get 3k Obo. Located in Denver Co

 

[Demonoid369]

Just saw these on Facebook. Jealous. Glws

 

[time2getdirty]

Trade you a rally car.

 

[1-tonxj]

I hate having to be patience welding my axles...lol...few inches one side mover over to other then find sonethibg to do until it cools and repeat process until done ...still can't see why you abandoned the project even if it took a couple years to finish atleast you have something that most do not because they can't commit to investing the time to see a big project to the end ...anyway hope you build something else to see you on trail with this looked like it was going to be bad ass ...

 

[jeepfreak1020]

Sorry David I'm not trading for a go fast lol.


Lol George, just doing something different. Time to move onto something different.

 

[1-tonxj]

Sorry David I'm not trading for a go fast lol.


Lol George, just doing something different. Time to move onto something different.

Building a buggy or switching hobbies ?

 

[jeepfreak1020]

Sold mods delete plz