4x4JeePmaNthINg
NAXJA Forum User
- Location
- Colorado
https://www.quadratec.com/products/...czVA7FrAjfz4Yy1mSqI2cKRANXtltgDhoCQawQAvD_BwE
I have a track bar with an end similar to this.
I was under the jeep today and saw my washer dangling from the axle side. That's new lol
I can't seem to get the "f...in" snap ring to lock into it's groove. It's off about the same thickness as the ring. I've tried all thread and sockets to press it in, but it's a no go.
Do I sand down the 9385 bushing or what would cause this?
Any suggestion, I've never encountered this?
Any help Much appreciated.
I have a track bar with an end similar to this.
I was under the jeep today and saw my washer dangling from the axle side. That's new lol
I can't seem to get the "f...in" snap ring to lock into it's groove. It's off about the same thickness as the ring. I've tried all thread and sockets to press it in, but it's a no go.
Do I sand down the 9385 bushing or what would cause this?
Any suggestion, I've never encountered this?
Any help Much appreciated.