Jeepspeed parts

chris_amrein

NAXJA Forum User
Location
fullerton
(2) 2.5 inch x 10 inch travel Dirt Logic resi shocks. Recently rebuilt with no miles since rebuild. $300

Dana 30 HP axle with under-axle 4130 truss. Brand new ball joints, brand new 4.88 gears set up by RWK, open diff, gusseted "C's", Blue Torch diff cover, lower shock mounts set up for big race shocks, upper link mounts changed to poly bushing and sleeve for 1/2" bolt. $450

Frame rail laminate plates. 1/8" similar to TMR plates. $60

Factory gas tank skid plate. $20

Parts are all in Fullerton. Local pick up only. Best way to reach me is by phone @ seven one four - two nine two - five zero one zero.
 
I'm interested in the front plates, I'll give you call later to schedule p/u.
 
I'll take the plates if Chasdb doesnt.

I'm in fullerton and can swing by anytime.
 
Can I get some pics of the dana 30 email or text work nine0nie nine10 six3six1 or [email protected] thanks

Pics sent

Also, to add to the Dana 30 info:

- The lower shock mounts are about 3 - 4 inches lower than where a stock shock would reside. This is done to get the travel needed for a 2.5 inch shock. You don't have to run a big shock; a 2" monotube or white body twin tube will fit as well.

- The axle doesn't have sway bar mounts and the bumpstop pads are gusseted underneath so they don't dimple or bend.

- The stock track bar mount is long gone and replaced with a new mount. Geometry was set up to work with a Teraflex or WJ high steer knuckle, but it could probably adapt to a stock knuckle as well, however whichever knuckle you use it will require a custom track bar. Simple enough for the buyer to make or I can make one for additional $$$.
 
Back
Top