- Location
- MilkyWay Galaxy
I have isolated my dry bearing noise sound down. I only here it at about 10-20 mph, in first-second gear at about 2/3rds of WOT. Never hear it any other time.
Front and rear drive shaft u-joints are solid, and not the source, and the front axle u-joints feel solid.
I have a tiny bit of looseness, slop side to side, but no fluid leaks yet in the rear driveshaft tail cone of the NP-242 transfer case where the output shaft and drive shaft connect. The case was filled 12 months ago when I replaced the AW4.
Could this noise be anything else but the slop in that location?
Front and rear drive shaft u-joints are solid, and not the source, and the front axle u-joints feel solid.
I have a tiny bit of looseness, slop side to side, but no fluid leaks yet in the rear driveshaft tail cone of the NP-242 transfer case where the output shaft and drive shaft connect. The case was filled 12 months ago when I replaced the AW4.
Could this noise be anything else but the slop in that location?