Harvo
NAXJA Forum User
- Location
- Chattanooga
A buddy of mine picked up 2 sets of spare front axles for me at a pull apart thinking they were a good price and that I may need them someday. They were complete with the unit hub and all. The other day I needed to change a hub, so I was just going to pop in a whole axle assembly. I got mine out and discovered they were very different.
Mine is a 93 country with HP D30 non disconnect. All the spares had smaller diameter axles (although they all end up with the same 27 splines) much smaller ujoint ears, and early model hubs.
I can't use the early hubs on my axles, so I got new hubs because my axles look much beefier... but, could I use the whole assembly as a spare still? It looks like it would move the WMS inward about a half inch because of the hub design, but it should all work as an assembly right?
Mine is a 93 country with HP D30 non disconnect. All the spares had smaller diameter axles (although they all end up with the same 27 splines) much smaller ujoint ears, and early model hubs.
I can't use the early hubs on my axles, so I got new hubs because my axles look much beefier... but, could I use the whole assembly as a spare still? It looks like it would move the WMS inward about a half inch because of the hub design, but it should all work as an assembly right?