Cherokee Crawl Swap Meet

[RedHeep]

I'll start. This is what I have/can bring:

'91 HP D30/D35 3.55 open/open
Rockcrusher D35 diff cover
'91 4.0 shortblock (needs rebuilt)
HO intake/exhaust manifolds
'91 factory roof rack

Make offers.

 

[yellowxj]

I've got a semi floater D60 w/ 3.73 gears out of a ford van IIRC I could bring...

 

[99NCXJ]

i've got lots of zj parts including glass, window motors, ect...

 

[87manche]

I have:

a crapton of dana 35 parts, all non-c clip.
one carrier 3.55 and lower
one carrier 3.73 and higher
a stupid number of spare shafts (if you still have a D35 and are coming, I will bring you shafts)
2 housings, setup for Mj's (likely going to scrap next week, pipe up if you want one)
stock Mj front springs
about 6 D35 brake backing plates.
about 6 D35 drums (been sitting, should probably be turned to remove surface rust)
Comanche Inner fender liners

I'm sure there's more, I just can't remember right now.

 

[Mark WNC]

I have a dana 60 front and sterlin 70 rear I think 93 or 94
I can bring if anyone is interested.
Stock 3.55 gears

 

[chopperdonk]

i have three almost complete cherokees if any on needs anything let me know

 

[RedHeep]

i have three almost complete cherokees if any on needs anything let me know

Are you coming to the crawl?

 

[chopperdonk]

yes i will be there friday morning

 

[XJCRAWLER]

i have three almost complete cherokees if any on needs anything let me know

What years?

 

[chopperdonk]

I HAVE TWO 93 2WD AND ONE 89

 

[Georgia Mike]

I need a front driveshaft!!!
:dunno:

 

[Ghost]

I need a front driveshaft!!!
:dunno:

Why didn't you tell me that when you were here?

 

[Georgia Mike]

Dunno? Why, do you have one?

 

[Ghost]

Dunno? Why, do you have one?

Yes, I also have a ax-5 and a 21 spline 231.

 

[The Hard Struggler]

I have a set of stock 8.8 axles and a set of R.E. 4.5" non ajustable control arms,brand new, went longarms so I don't need them.

 

[RedHeep]

I'll start. This is what I have/can bring:

'91 HP D30/D35 3.55 open/open
Rockcrusher D35 diff cover
'91 4.0 shortblock (needs rebuilt)
HO intake/exhaust manifolds
'91 factory roof rack

Make offers.

D30 is gone.

How much for the 8.8?

Also WTB set of D30 shafts in a 297 variety.

 

[Georgia Mike]

I'm probably gonna build an extra set of rock rails and bring them to sell if anyone may be interested.

 

[chopperdonk]

how much for a set of rock rails

 

[Georgia Mike]

Sorry, I think they've already been spoken for. After the crawl I could build you a pair for $150, if you'd still be interested....

 

[RedHeep]

I have a set of stock 8.8 axles and a set of R.E. 4.5" non ajustable control arms,brand new, went longarms so I don't need them.

How much for those axleshafts?