COJeepin
NAXJA Forum User
- Location
- Denver, CO
Taken off my XJ so will bolt right into any XJ or anything else with some work.
1. Front Currie High Pinion shaved Ford 9" (Dana 44 knuckles/outers)
- 31 spline Moser shafts (passenger outer is a Chromo after breaking the Moser outer last season)
- Yukon Super-Joints
- ARB locker
- Warn Premium locking hubs
- 4.88 gears
- Bolt pattern is 5 on 5.5
Will include the following spare parts:
- Chromo inner and outer shafts
- Set of new Warn hubs
- ARB mini air compressor (will easily drive front and rear lockers) with switches/wiring
- Set of new brake pads
- Steering ram and high steer arms from hydro assist
I have $5500 in parts into this axle, asking $3500 for it.
2. Rear Ford 8.8
- 31 spline Mark Williams hi-torque shafts with c-clip eliminator
- Detroit locker
- 4.88 gears
- Bolt pattern is 5 on 5.5
- Superior diff guard
Will include a brand new Super-88 kit that has never been used.
I have $3600 in parts into this, asking $2200 for it
I will sell both for $5200 bottom line (little wiggle room on this), so make me an offer.
Both axles are 64 3/4" (WMS to WMS) with a 1 5/8" spacer on the 8.8 (they are narrower than stock Jeep axles).
Axles are located in Longmont. Email me at [email protected]
1. Front Currie High Pinion shaved Ford 9" (Dana 44 knuckles/outers)
- 31 spline Moser shafts (passenger outer is a Chromo after breaking the Moser outer last season)
- Yukon Super-Joints
- ARB locker
- Warn Premium locking hubs
- 4.88 gears
- Bolt pattern is 5 on 5.5
Will include the following spare parts:
- Chromo inner and outer shafts
- Set of new Warn hubs
- ARB mini air compressor (will easily drive front and rear lockers) with switches/wiring
- Set of new brake pads
- Steering ram and high steer arms from hydro assist
I have $5500 in parts into this axle, asking $3500 for it.
2. Rear Ford 8.8
- 31 spline Mark Williams hi-torque shafts with c-clip eliminator
- Detroit locker
- 4.88 gears
- Bolt pattern is 5 on 5.5
- Superior diff guard
Will include a brand new Super-88 kit that has never been used.
I have $3600 in parts into this, asking $2200 for it
I will sell both for $5200 bottom line (little wiggle room on this), so make me an offer.
Both axles are 64 3/4" (WMS to WMS) with a 1 5/8" spacer on the 8.8 (they are narrower than stock Jeep axles).
Axles are located in Longmont. Email me at [email protected]