A little trimming for the new sneakers.

[CSaddict]

I got the itch to do this while I was welding. So I just went at it. No measuring bullshit. Can you tell I dont care much about it?

Here it is with my new 33x12.50 Maxxis Big Horns. Its got a 4" hybrid lift with mix matched RE and RC parts.

I dropped out of the Phil Larocca school of fender folding so this is how I did it.

Still have some finish work and some fender trim to add.

For comparison, here is my daily driver that tucks 15's

 

[evil dead]

what did you use to cut with i had to do it one day but only had a 6in angle
w/a cut off and my cuts are not so clean but in all seriosness you need to fold the seam over behind the front tire its a tire cutter

(you may not have this problem as i have less lift)

 

[blackdoutxj]

is it on stock gearing?! looks good btw...im gettin the same tire only in 32 x11.5 on a 4" lift!

 

[CSaddict]

Stock 3.55's for now. Its getting Aussie's front and back with 4.56's soon. I am planning on finshing the fender trimming with some molding.

 

[WheelinJR]

Lookin good Dave. What happened to the CRX?

 

[ADVNTURR]

I've been looking to do a little trimming myself. Just curious what you did with the inner front fender liner, I'm assuming you just tossed it? Also, any pictures of how you took care of bracing the front part of the fender after you removed the lower portion under the marker lights?

Thanks

 

[ZachMan]

I've been looking to do a little trimming myself. Just curious what you did with the inner front fender liner, I'm assuming you just tossed it? Also, any pictures of how you took care of bracing the front part of the fender after you removed the lower portion under the marker lights?

Thanks

chunk it, bracing what bracing?

 

[CSaddict]

The CRX was sold a while back. The front liners are trash can items. the brace was cut off.