Recent content by XJcrazy

Sometimes its better to be lucky than good. One good tap on the dash and guess what, it works! Sweet

Pulled my VSS out and attached it to a drill, just like when I drive down the road my speedometer is not working but the odometer still works as it should. Its only a 2 wire sensor, possible one side is for odometer the other for speedometer???? Hoping its not my gauge cluster. Any help is...

Sold , Thanks Paul..... Went back to AZ...FYI , I called Mike at Proto Fab and asked him how he normally ships them... REGULAR UPS... the trick is it must be in 2 pieces or it easily goes over the weight limit...

Really want another XJ ....

use UPS freight ...

Shipping would need to be figured out on your end..... Try freight quote ... I would guess around the $75 range... It may be heading back to AZ ....

For $450 I will throw in the aluminum wheel pictured and (2) tires. A 30" Goodyear Wrangler and a new Firestone Destination M/T

Great bumper.... should keep it for my next truck but I really want a super low milage truck and I know Im going to have to spend the $ to get it. (904) 838 8838 Capt Adam - Located in Jacksonville FL. I had it custom made for me with (2) 2" recievers.... allows the use of a bike rack...

Just sold my 7th XJ.... looking for another... IF you see or know of a super clean 4x4 with less than 50k miles... please contact me. I live in JAX FL... 904-838-8838 Should have a " spotter " section in the forum for trucks...

I didnt try anything else because Advanced Adapters recommended them to me, they said they tried various styles but with it being so tight, the block huggers were the only ones that would fit..... Im having a really hard time trying to find huggers that can be used on this 383.... need to be...

as far as headers, those were standard hooker, block huggers... its the only thing that would work... Im actaully having difficulty finding a company that makes a block hugger header with 1.75" primaries and 3.5 to 4.0 inch collectors.

yeah, I used Advanced Adapters motor mounts as I will again except Im going to replace the rubber bushings with solid aluminum.... to the hood guy, its to bad you didnt catch me about a month or two ago, that hood sat in my garage for a year before I sold it to some kid for 200 bucks..

it was an XJ with the back half sawed off, not an MJ but thats ok,, As far as the number I have no clue... I remember when I got it I stood in front of about 200 hoses and I picked out that one.... It just seemed to have all the proper bends in all the appropriate places..lol good luck bubba

Great video's, Thats pretty much what Im going after.... I sure like the coil over set up he had on the front end... Yes, Advanced adapters makes motor mounts for the swap. Im working with Ron Davis to do a NICE radiator that will handle the heat and mount in the factory location.... Needs...

I tried selling the LT1 Vette motor locally but I think its too high tech for me and the rest of the red necks around here. Of course , you can put a different intake and carb on it... but its only good for 320hp at that point.... I tried posting it and a transfer case for sale but for some...