Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I had the ground hooked to the solenoid stud it was a stupid move on my part I should have known better. After I cleaned up all the grounds with a wire brush she started right up.
Thanks for all the replies guys.
Alright so I got a new harness and installed it the correct way with no ground running to the starter then I connected all my grounds to the block. Went to start it and it still would not crank just a click followed by 2 quiter clicks like I had a dead battery. I know my battery is good. Is...
Ahh okay that makes sense I will run that ground to the engine block and im assuming the ground I have connected to the ground point at the #4 cylinder goes to the starter.
I haven't done any electrical mods on this truck but at some the PO has its a birds nest in some areas (thats my next...
I just swapped in a new Engine into my 87 Comanche 2WD 4.0L. (the motor was from a 99 but I swapped all the sensors, and brackets over...except for the block coolant temp sensor which the block was not drilled for.)
So upon startup for the first time I plugged up my battery (which is the...
I Installed a flywheel for a 2000 which is my year so I know thats right. I did not unplug the TCM. Its located under the center console correct? The CPS is plugged in but I did have a hard time getting the trans to line up so maybe I bumped it on the flywheel I can pull it out and take a look...
Need some help on getting my Jeep running here hopefully someone can help me out.
I have a 2000 XJ I just swapped a NV3550 (manual) into it. It was an AW4 (auto). Overall the swap went well. If you have any questions feel free to ask. But now my problem is she wont start. The starter turns over...