Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Good to know. Yeah, I noticed your website says: 'almost .25" wall'. I wonder if RR uses the same, because I had no problem fitting the tap after chopping a few inches off the rod, even though theirs is described as 1/4" wall.
I believe they use a 16tpi end, since it's slightly larger than...
I have a new TRW ES2233L 1-ton TRE drilled and reamed to fit an ES2026R on an under the knuckle set-up. $35 pick-up or plus shipping from Christiansburg, VA.
I'm doing an otk conversion and screwed up and reamed the tre from the wrong direction. If you've got an utk set-up it'll work great...
Just got around to doing this. The RR ends are NOT 18 tpi. So I'm needing to get a LH tap too to make these work, which isn't cheap. So now, it would have been cheaper to just buy the kit from JCR, but in the event I screw up a rod I'll have what I need to make a replacement. Plus this way I...
I just picked up the RR set-up for cheap, and I was looking to do the same thing. I was previously planning to get the JCR OTK kit, but for the price I got the RR linkage...
Here's my plan: Replace all the TRE's with the same part #'s JCR uses. They Both use 1.25 Dia .25 wall DOM, so the real...
It'd without question be better than sticking with 3.55's. The 4.10's would give you about the same performance as stock gears and stock tires, was my point before. If you crawl much with it though you may want to go deeper.
Back to the OP... the RC brackets don't have braces do they? But for basiclly the same money you can get the RR which do. My biggest issue is RR's customer service. that's the only thing stopping me from getting theirs.