Recent content by uglyrenixxj

I had this issue many years ago when i bought the xj (89) and did the typical tps replacement and adjustment (w snap on red brick scan tool). Im pretty sure that the guy before me sold it because he couldn't figure out the high idle a startup. In the end, someone had smacked the throttle body...

I realize its a bit late, but ive been running a "tefba" coolant filter for about 15 years w zero issues Ebay has them for about 60 bux U.S..

spruzzare il getto rapido dello spray di avviamento nella piastra dell'acceleratore e provare a ricominciare. se inizi, hai problemi di consegna del carburante. possibile che un piccolo tubo si sia staccato dalla pompa all'interno del serbatoio del carburante. togliere il filtro del carburante e...

For anyone searching this topic in the future, know that four seasons part numbers 14720, and 14718, are 90° elbows that replace the factory compressor shut off valves (that leak more often than not). These new parts numbers include suc, and dis fittings for 134.

High beam switch actuator.....and it is a BEAR to get back in.

Have checked any of the valve train? Used a vacuum gage on, then ran it up past 3k? Rocker arms tight?

Checked the flexplate?

So, Digging into a topic that has been somewhat covered, im looking for a sanity check..... This thread (post 116, and 117 specifically) pretty much sums up my situation.------> https://www.naxja.org/forum/showthread.php?t=1015963&page=8 in short, they contradict eachother. 1 says release...

Keep us posted...............

I chased a vacuum leak at the transfer case vacuum switch longer than i like to talk about on my 89. Idles like a satisfied woman with a belly full of in n out.

I had a "brand new" CPS from napa, take a dump in less than 30 days in my 89. Ohmed out perfectly.....

couldnt fing any plugs or patches in it. Still has PLENTY of meat on it. Perfect for a trail spare. FREE NINETY NINE! MURRIETA 92563 SCOTT AND 215

Pump oring and seal All fork pads Shift rod bushings I sourced all my parts from ebay and Amazon Also, save some headaches and get a decent set of LOCK ring pliers if you dont already have some.

If you want any help, im in murrieta, and i have the snap on mt2500 scanner

Rebuilt mine 4 months ago w a kit from napa. A word of caution.... mark a few index marks before you fool w it, and watch as many youtube videos you can find. Biggest pain for me was getting the FIRST ball bearing down o to the worm shaft during assembly. The rest was pretty easy