Recent content by typerr

If you are rebuilding your 1995 motor anyway than do what I did and upgrade your intake manifold at the same time to the later horseshoe manifold. Mine is ported to match my ported Pottenger head. The newer manifold requires a different power steering pump and brackets and uses the much easier...

JCR seems to always have a Black Friday sale. I got a great deal on my bumpers a couple years ago.

When I did the head swap on my XJ I ended up building 3 similar 12" high platforms out of an old 2x10 I had sitting in the rafters of my garage. Took me a couple hours to design and build.

"DipStick Upgraded to 97+ XJ" Does that count as an upgrade?

^^^ Yup, just did this same manifold swap on my 95 XJ. The belt is soooooo much easier to adjust with this newer setup but the belt needs to be very tight or it will squeal when you use the a/c (as I found out).

^Did the same except I bought my harness from LMC truck. Not sure what I spent but the difference over the original setup was worth every penny plus another $100. What was Jeep thinking??

This is great! I'll be ordering a similar panel after I get my cylinder head back from Russ and back on the Jeep. Thanks for the write up Anak! Those Anderson Powerpoles remind me of RC car battery connectors...

Also a weekend warrior, not a pro but I've been collecting and using air tools for 30 years. I've had great luck with the Harbor Freight Earthquake line. The latest version is very lightweight and has been working great for me. I always print out a 20% off coupon before I go to HF...

HD Offroad makes a great product and I have the same no-lift brackets on my XJ as well but I did end up exchanging one bracket because it was bent too tight to fit my shackles. Is it possible you just have a poor fit or the shackle bolt is not drilled straight causing the shackle to rub. Rather...

Not true. Look up the install procedure and you will see that yes there is one position for the body of the distributor but you also have to line up the pulse ring alignment holes with a punch before you install.

Your cam position sensor is built into the distributor. Are you sure the distributor was installed correctly?

The reason I've been watching this thread so closely is because Russ has been building a full port head and matching intake for my (non-stroked at this time) 4.0 project. I'm also going with the same cam as RCP and can't wait to get all this goodness back on my Jeep!

My understanding is Dynojet (and other chassis dyno) pulls are done in your 1:1 gear to remove any effect of torque multiplication so the dyno operator will shift up through the gears to get to the proper ratio during the session.

Does anyone know if the Banks XJ headers come with a Carb EO# and sticker? I tried the Banks website but could not find the info. Thanks.

Looks like the all aluminum 2 row version is due out in September. https://www.mishimoto.com/jeep-cherokee-xj-aluminum-radiator-1989-2001.html