Recent content by treky67

now is this a part you can source from your local parts shop or is this some thing you need to source aftermarket?

ive searched and seen many threads but nothing with specific information. especialy when it come to the disc brake swap, specific parts needed etc...

i'm just about to start a ford 9" and dana 44 swap into my cherokee, and i was wondering if the driveshaft U joints are the correct size for the ford 9" and dana 44 yokes? Or if some one could point me in the right dirrect of a good built with this swap. Also looking for good information on disc...

After several overheating issued occured at a local mudrun(pics below) i decided to remove my ac condenser and add a second electric fan. This alowed the rad to be easily cleaned once it was plugged full of mud. And i needed the ac compressor and mechanical fan removed for my grand cherokee...

Another update, i re-did all of the floor, as well as instaled some offbrand offroad suspention seats. These will be mounted to the roll cage with 5pt harnesses in the future. And i did the truck bed liner inside as well. I used a canadian stuff called easy liner. worked great.

so i haven't posted in a very very long time, but ive been wheeling a couple of times including a big trip up north. but not alot of pictures. i will post what i have tho. As well ive started building a set of tube fenders. pretty much have the fronts done. Not quite sure what i'm doing with the...

really i just used a 1/4" plate and bolted in to the 4 factory bolts and then used 2x4" tubing out from there to support to top plate on the bumper and the front plate etc...But at the same time its for very strong at the moment and am not 100% sure how i'm going to make it stronger. If any one...

well at the moment i don't have a spare tire and usually just wheel using a plug/patch kit. But on a recent trip i busted up all the tailgate and rear window from a tree branch so, its also going to act as protection for the rear of the jeep/storage rack and possibly a tire carrier in the...

The tire carrier will be both attached to the tail gate as well as some kind of safety pin at the hinge point. that way its not relying on only the the tail gate for support.

Okay so i haven't posted in a while but i have been working on the jeep so here are a few update shots of both the front and rear bumpers. And for the rear bumper i'm also building a fold down tire carrier stinger. Finished all the gussets for the front bumper and fully welded it so all thats...

hey cool a subscriber i can't say ive ever had one of those yet. Well if other new , what gives almost 600 views and replies from only one person. Is it because i'm Canadian? Just kidding i think the thread need to me moved to the fabricators section but you need to be a paying member from what...

Started on the tube work for the front bumper so far so good seeing as how ive never really done to much tube work before. Also made up some fancy gussets and will try and make the rest of them so what match to get a theme going. I took a few pictures here and there just to show progress is...

Hey sweet a reply, and from a fellow Canadian. Thanks

Next it was thrown up on the bench/folding table and the last few piece where added and every thing was burned in. And last but not least back bolted to the jeep to test fit and take some pictures. It turned out much better than i was expecting and i still would like to add a stinger...

So made some very good progress on the bumper today had my buddy matt come over and hit the grinding wheels hard. 3 hours later we arose with this need to finish welding grinding and at a few supports here and there. I ended up using 1/4" steel because is was a little more available. Started...