Recent content by Traverse

The sensors need to warm up to give a good read. 10 to 60 sec on most gear, dont know why.

It depends on the gears that are in there. 3.07's you dont have to remove the ring gear, anything deeper and you you will.

Heres one. http://www.ringpinion.biz/index.php? cPath=26_60_249&osCsid=30c1735a12a3cf9e5b8ff99111514bfc

Try xdtalk.com

I run a spool in my 44 and daily drove it for about 9 months, It wasnt bad on the street at all but sure did run through tires real fast.

Jam pool noodles in there.

8.25 wont fit a 44...I tried.

I used to powdercoat and a women would bring in her tables and what not to have clear put over em. The colors and patterns she could make were outstanding and the clear coat really protected and helped to set off the color. not sure if its the same lady, but the same technique. She sold her...

Ballon fiesta starts on the 6th. Flying star is a nice coffie shop kinda place, 1/8th mile from UNM. The Jemez mountians are about 2 hours away. Tram is cool but will be slammed cause of the ballon fiesta, but there are paved roads all through the Sandia mountains. you can drive right to the...

The plastic ones on the outside? I just got the dremmel and ground them down till they fit tightly.

Im installing an Aussie locker into my dana 30 and all seems to be goin well, but i can not get the Roll pin to go back into the cross shaft. It dosnt even get far enough through the carrier to reach the cross shaft. I am putting it in reverse of the way it came out. Any help is appreciated...

I bought some Yukon shafts from him. Other then the box getting shipped to NE instead of SE address, partly my fault i guess, I had a fine exprience. He answered my questions in in timely manner and shipped to the neighbors house very quickly. I would buy from him again.

Other than a stuck fuel injector and bad rings, what could cause this problem?

I will try that tomorrow, and hopefully avoid the last part.