Recent content by tomcat

I was thinking of doing the exact same thing, but using a trans mounted PTO pump. Are you worried about how much more the rear suspension is going to move around compared to a tractors? A couple companies make 3 point hitches for ATV's that i was think of modeling mine after

Well mopar cps went in, still no start :( What else 'ya got?

ordered a mopar unit this morning, we'll see how that goes

Fuel pump runs, and i swapped the asd relay with the elec fan relay, and another good relay, and still no go. Door chime was because i had the door open (duh) No sentry key either, normal black key Still no start.

I have a 2000 XJ, 4.0 auto, 230K miles. I had moved it to the back of my property when we had tree guys coming, and weeks later when I went to start it again, it would not go, it just turns over. since it was on a trail, and I thought it was the CPS, I left it all winter, and pulled the...

junkyard swap, they are $75 at my pick-n-pull all day long. swapping yourself isn't all that bad, but for a first time swap, give yourself plenty of time. getting the new trans up in the air is tough if you are alone (motorcycle jack helps keep it steady, or i think they make trans pads for...

i was going to use this: http://claytonoffroad.com/product_info.php/cPath/18_122/products_id/359 and this: http://claytonoffroad.com/product_info.php/cPath/18_72/products_id/165 and a couple of these: http://www.ruffstuffspecialties.com/catalog/125RESET.html to put together a 3-link kit for...

nice, my stroker is painted race hemi orange

I have a semi-float Dana 60 out of a 2005 chevy 2500 van for sale. it is an 8 lug with 4.11 gears, open carrier. very clean, has caliper brackets and e-brake hardware, but no calipers or rotors. looking to get $500 OBO.

arb part number 728B041 (only available as a 6 gear set) Source (see note 3 on bottom left): http://www.arb.com.au/media/products/air-lockers/2-RD06.pdf quick search indicates that Poly Performace sells a set for $309...

MJ and CJ are both spring-under, and a 44 from a CJ may be a narrow track as well 29 spline 8.25 is going to be your best bet

i ran 31's locked front (ARB) and rear (Detroit) with a D35 for 3 years with 4.11's, 2 of those years have been with a 4.6 stroker...:explosion and still haven't had a problem. i credit that to the riddler cover stiffening up the rear. if you already have good tires, lock the front and...

i used zj D35 tone rings, and they were the same as the XJ tone rings. i had two pair side-by side. had the tone ring milled out, and then ground down the axleshaft. heated up the tone ring and sent it home. sensor mounts do not have to be modified at all, they bolt right up after you notch...

finally took pics of my XJ 44 with ZJ brakes setup to post up too Parking brake by xjeep, on Flickr Abs sensor passthrough by xjeep, on Flickr Blocked bolt by xjeep, on Flickr Backing plate by xjeep, on Flickr

http://www.jeepstrokers.com/forum/ get to reading. you have a LOT of possibilities. i built a heavy crank short rod with a comp 231 cam, bored .030, decked block, but would probably do a light crank long rod next time, but i am still absolutely in love with this torque monster 10k miles later