Recent content by tfluthy

So to confirm, assuming my reman transfer case is a 242J and not a 242HD (I haven't double checked, and hopefully the reman firm didn't make a mistake) the rear slip yoke should work fine. The 27 spline output shaft on both the 231J and 242J are the same diameter. The front output yoke on the...

I'm going in on Monday to discuss the point. The shop is kinda small, and generally does good work, but doesn't like doing anything out of the ordinary. Switching out a 231 for a 242 is out of the ordinary. If I have too, I'll get them to put the rear drive shaft in and drive it home in 2wd...

note: Measured length of existing front drive shaft is 31 inches compressed

My son managed to blow up his 231j transfer case because of reasons. Anyway I want to put on a 242j transfer case. 2000 xj 4.0 automatic transmission Sport trim No lift I have the linkage off of a 242 jeep, bezel, shift gate. Reman 242 from midwest transmission The guy I have doing this...

I got one thanks. I no longer need this thread open. do I need to do anything to close?

https://www.customconnectorkits.com/products/15380782-pt?variant=47056856121662 Look what I found

Son blew up xj transfer case 200 miles from home. Had a 231 replacing with 242 so I need shift gate.