Recent content by TealV6

I'm looking for the Stealth or Vantage box for a 97-01 Cherokee. Does not need speaker if you want to keep yours. Let me know what you have. Steve

I'd be curious to see the pictures :)

You do paypal on the RE brackets? Steve

Well... have the RE 3.5 superflex but upgraded to the 4.5 full rear pack... which brought the whole Jeep up almost 6 full inches. The DT shocks are had... they've given there lives in the name of height. I use this more for DD than wheeling right now because of time, so I'm looking for opinions...

With all the lower skinning, have you noticed any extra weight in the doors? My only worry is with my 2 door they already have a tendency to sag more than the 4dr models.

2 dr or 4 dr? Do you still have glass? Steve

Is this the GM style turn signal stalk?

Ok.. haven't had much time (thanks to job) to get some testing done. But I have been trying to pay attention to shift points, where/when i'm having issues. I'm starting to think at this point some of this might be motor related. I say that because just in general, it will not go above 3K...

Usually, the small cup is the rear set. Check to see if you have a bad wheel cylinder. Should be visible by fluid on the back side of the rim. Steve

Well.. after seeing the last post. I'll throw a few more details that might have been missed somewhere in the translation. Let's go back to Monday. I did have him remove the Dexron or Mercon V he put in, only problem was, he put in a synth atf+3 now. I am running MUCH better. Only having...

Hmmm... did I upset people?? Not used to not seeing nothing posted. But anyway... had the mechanic change the fluid out again. This time using ATF+3 synth blend. This DID correct 99% of the issue. Only thing now is WOT has a bit of a stumble over 3500 RPM before shifting. That to me is...

Ok.. so let's start with.. it's not fixed yet. Now.. this all started with me wanting to do maintenance on the ol girl because the thought of new Jeeps make me cringe :gag: So the big stuff I let my mechanic handle and the smaller stuff I do (most based on time and he has a lift). So I wanted...

Think I got the problem... going to run her for a short bit while going to the Moto show. When I get back.... IF it's still running good, I'll post my findings. Thanks !! Steve

Well.. I need help guys. I'm at a loss here. 1994 4.0L with auto. Just had trans serviced and coolant flushed. After that, it will not move under hard acceleration. Expecially on the freeway (passing, going up hill, etc). I've done cap, rotor, plugs, wire, O2, MAP. While it also seems that the...

Now that was funny :laugh3: