Recent content by spidermikey88

Not all today but over the last few months I installed Bilstein shocks, replaced some bushings and finally installed the rear frame stiffeners. Still need to install the front stiffeners eventually Sent from my Pixel 5 using Tapatalk

Took the jeep and gf out to play in the snow. The jeep was running super cold. Never got above 170 and the heater wasn't doing much. I guess that's better than over heating but I'll have to look into it before my next snow trip Sent from my Pixel 5 using Tapatalk

Swapped out a leaky transmission cooler line this morning. Somehow the rubber part got pushed up against my harmonic balancer and it ate a nice hole in the line. My serpentine belt also looks pretty warn out and I'm guessing that's from rubbing on the tans cooler line. I guess I'll be replacing...

I got the renix kit, XJREN2GA. And yea, I went with 2 gauge. I mounted the fuse on the passenger side just behind my battery. I'll try to get some better pics of all the cables be daylight tomorrow if you want. I like them. I didn't notice a huge difference but I think that I will once I run...

Thanks! I have a some 2x6's that I'm thinking about doing that with someday Sent from my Pixel 3a using Tapatalk

That's a nice looking bike! Sent from my Pixel 3a using Tapatalk

They sure did! It's a much smoother ride now and not quite as much poping up front :). I still need to install the front and rear frame stiffeners then it should be pretty solid all around. I also received my Detors knocked bone rear tire carrier and got it painted and mounted. It's pretty nice.

Water pump gasket blew out. Got the old stuff removed and cleaned up. Will be installing a new pump, thermostat and tstat housing later today. This happened a day after taking the jeep on a ~500 mile camping trip/trail ride. I'm glad it waited till I got home to blow! Sent from my Pixel 3a...

Swapped out my upper/lower control arms and bushings. Those axle side upper bushings are a huge pain! Sent from my Pixel 3a using Tapatalk

Finally tracked down a problem I was having with my steering being a hard in a few spots. Steering shaft ujoint on the fire wall side only moved in one axis. Those are a pain to replace. Sent from my Pixel 3a using Tapatalk

Replaced my driver side axle u joint. Hate u joints but i think it was time Sent from my Pixel 3a using Tapatalk

Installed The Big 7 from Jeep cables. I had planned on installing adjustable upper and lower control arms that I ordered from Protune Suspension but it look like they sent me the wrong uppers :( so that'll have to wait. Sent from my Pixel 3a using Tapatalk

Finally finished the mid sections! Re-primed then and got the first layer of under coating on. I used some Rust-Oleum primer and then wire brushed it off where I welded. I was mostly worried about the back side and didn't want to leave it bare metal. Sent from my Pixel 3a using Tapatalk

Started installing my HD Off Road frame stiffiners. Sent from my Pixel 3a using Tapatalk

Finished the ZJ brake booster and master swap on my 91 2wd and threw on my old 31's. Still need to fix the rough idle, leaky sunroof and look into why the font driver side is leaking grease - then it should be ready for the gambler 500 this year... If it isn't cancelled. Sent from my Pixel 3a...