Recent content by SLaSHeR

Problem solved. Thanks to everyone for your feedback and advice. Yesterday (Saturday), I started bright and early with a tungsten carbide cutting bit for a dremel which made quick work of that stuck titanium bit in the TC output shaft. When I say quick, I mean about 2 - 3 hours of straight...

Hey thanks again to everyone for the feedback. I am going to try a couple of things this weekend and hope for the best. If I can't make any progress then I may have to reach out for an extra shaft some of you have laying around. I'll keep you posted. Thanks again.

Thanks to everyone for all the feedback thus far. Yes, I do have an NP242. I spent a few hours yesterday trying to drill the bit out using both left handed cobalt bits and regular titanium bits. To be honest, I don't think I made any noticeable progress. So far I have been trying to do this...

My buddy & I were installing a RE SYE hack n tap on my 99XJ without removing the TC. Everything was going smoothly until he snapped off a bit while drilling a pilot hole in the hacked end of the TC output shaft. It is a 1/16" titanium bit drilled in about 1" deep. The bit broke not only at the...