Recent content by skipabeat

I have given up... i just don't have the time, tend to neglect the kids and wife while the Jeep gets all the attention. The head was checked by a shop and was given the okay so i don't know. What i wanted to do was replace the motor in the first place but got talked out of it. Did pour oil in...

I want to thank everyone for their help! Sadly after a compression check the number four cylinder has suddenly lost compression :soapbox: so no going any further i guess! Any one interested in a Jeep with a good body and bad motor????? Thanks Again Joe

I don't here anything in the run position.

Interchanged the 3 still the same, they all have the same numbers. I had the volt meter set to 20 dcv is that correct?

Not 12v just 0.12v

Yes i did.

Well I'm getting 0.12 v at the coil to the distributor and the same at both coil terminals

Yes i replaced the crank sensor because i could not get a good reading on it, everything seems okay as far as connections go.

The battery is putting out 12.80 at the posts. It is well charged. used a straight hex into the wire to the block, plug and anywhere else you can think of. Then my neighbor held it in his hand to the block and he is still alive! How can i check power to the PCM ?

Purchased a meter and when i came back my internet was down for the day. I'm getting 10.50 at the battery cranking the engine so that's not the problem. I would like to test my new coil and anything else someone can come up with to figure this thing out. I still have no spark ......none.

I'm going to buy a volt meter right now, so I'll get back to you on the battery.

I smell fuel, there is fuel to the fuel rail, plugs seem to have fuel on them but i would not say ...soaked. I did not touch the distributor, i checked the firing order and its correct. I do not hear my fuel pump make any sound when the ignition is turned on. Where can i find the ASD? Is there...

Ran before the head gasket went, triple checked all connections. I agree with you I've thrown enough money into it, how can i check for anything else?? Some posts mention asd but i have no idea what that is?

Re: No spark now what? Help!! Well before i put this thing on Craigslist i will give this one more shot! Replaced the crank sensor and still no spark, so the list grows plugs, cap, rotor, coil, crank sensor. Read in one post something about the fuel pump having to make a sound as the key is...

Spent the weekend putting on a head gasket and now i have no spark at the coil or plugs. My 98 Cherokee 4.0 just cranks, I've replaced the coil, cap, plugs.................what next? Could it be the coil pickup, how can i check it? Thanks