Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I have a HpD30 I'm building right now. Is getting 4:88's and the works. I have OTK steering so while I'm doind the gears I figured I would move the trackbar OTA. My question is where should I put the track bar bracket in relationship to the other tabs? I didnt know if I put it to the inside or...
ChiXJeff, were did you buy your over-axle bracket? Did you have to buy a straight track bar? I've noticed theres not much room on top of the axle since I have the controll arm mount there, any way around that or is that ok? Thanks!!
I'm runnin JCR 1-ton OTK and previously had the same track...
I just installed the OTK set-up on my XJ. But now I have bad death wobble. The last run I went on with my old set-up I had a little on the way home,, but I fugured it was because of the mud in my wheels. Do you know why it would be worse with the JCR kit? I had a stabilizer before now I dont...
So yo want the threads on the TRE's sticking out just enough to see the hole for the cottar pin ya mean?
Cool, I'm exited, I'm going to get the reamer, and 5/8 and 11/16 bits tomorrow so when my kit comes in I can slap some paint on her and be good.
Thanks for your help though!
Thank you, I'll buy that tommorow. was it hard reaming the pitman arm? And how did you check the "ream" did ya just put the tie-rod end in till it was kinda snug? How should they fit in the knuckles and pitman arm?
Thanks for the help.
Putting the stabilizer on will just "mask" the problem so the true prblem will still be there and may get worse.
I just ordered my 1-ton OTK set-up about a half hour ago. I cant wait till I get it.
Probably just going to buy the snap-on reamer though. I dont wanna deal with e-bay and my...
Do you think I can get the JCR kit to replace my rustys inverted Y set up but get heims for it or should I just keep the 1ton ends?
Sorry, I'm getting overwhelmed....
Thanks though
Thanks for your help, I'm going to go outside and swap out the tone ring to my nex axle. And thank you for not advising me to disable ABS because its a bad idea. ANd my lights not on yet, I dont know why.
I just got a non ABS driverside front axle for my 96 XJ from the junkyard but my XJ has ABS and since the new axle doesnt have the wheel speed sensor my when I get on the brakes hard the frint end skids a little. If I remove the fuse would it stop this? If so, were is the fuse?
And finally, can...