Recent content by sean87xj

I can't believe I originally posted this thread in November of 2007 and this poor Jeep is still sitting in my driveway. I haven't really messed with it at all since the last update, brakes are still dragging, pressure is getting trapped in the system....I'm just not sure where. If I wasn't...

Oh, another thing I should have mentioned.....when you yank out your old ABS master cylinder, hang onto it!! Every single nut I needed for the new setup was found on there....and I even had a few spares, which was good because I destroyed a few with a vice grips. I had to buy one 2' section of...

Also, here's some tips for all the other poor saps trying this job who might stumble across this thread in the future: 1) Prior to doing this, I had never once cut brake line in my life and I was confused by the whole double flare/bubble flare situation, and didn't start to understand it until...

OK! I finally finished this, everything went fairly smooth once I stopped being lazy... Big problem, however....the front calipers appear to be dragging, BAD....as in, the car will come to a complete stop by itself very quickly from under 30MPH and accelerating is a noticeable chore. This only...

:doh:

Nice, thanks! Looks like I had the lines from the MC mixed up... Did you have to swap pedals when converting yours? I think '90/'91 might be slightly different in that regard but I'm not sure. I'm pumped now, starting to see the light at the end of the tunnel. Next step is to switch those...

OK, I may have answered some of my own questions.....tell me if this is right, I found this picture online but it looks almost exactly like the prop valve from my '91 ABS setup... 1) Front Inlet 2) Rear Inlet 3) Front Right Outlet 4) Front Left Outlet 5) Rear Outlet #3 & #4 are plugged on...

Alright, dragging this one back from the dead... I haven't really had any time to work on Jeeps in the last six months and just started at this again. I've got an '04 WJ Booster (need to get an MC). I was wrong on the year of my Cherokee, it's a '91 and test fitting the booster, the rod seems...

Thanks, has anyone used the WJ prop valve and gotten it to work?

Hi guys, first post here but I've been reading this board for a long time now and it's great. I've just started ripping out my '89 Bendix-9 ABS for replacement with a WJ master/booster. I've read all the threads I could find on it and I know I'll run into some issues later on that I can...