Recent content by Ryno

lol

Love the look of the fenders! Wish I had a set

If She can do it.... you can do it!

I miss my old red '94. Looking good! Keep it up, I know that there are a lot of people on here that would like to help you out with the hand me downs.

I had a problem like that with mine, problem was the trailer converter module was shorting out and messed everything up... I cut it out and got a new one. Not sure exactly if this will help you but I guess it can't hurt.

I found it at "Canadian Tire" but I am sure that they can be found at "Wall-mart" or "Target". I don't like the stick on mounts because they always fall off on me!

Got an idea the other day so I decided to make my own mount with the aid of a cheep holder that I had. Got tired of it falling out of the air vent so I made this. cut temp out of cardboard cut out from scrap I had, don't know how thick made a couple bends to match poped the cheep mount on to...

Drink and drive.... now where to put the keg!

lol

Good idea! You could put some JB weld between them and then screw them... might spread out the load more then forcing the load on two points (the screws). Just my two cents, I like your creative problem solving!

How were those roof lights done/set up? I like that look and have been trying to figure out how to do mine. Any kind of information would be great.

Worked for mine! I didn't know that there was a way to turn it off and on like that. Thanks

Any more pic's of the light bar and how it is setup! Giving me some ideas I tell yah! Looks great... I want one like that.

Change the switch, cost like $23.50 or go to the pick and pull and find one that will fit... cost $2.00 or so if you are lucky

check the connector down the drivers side by the air box. My old jeep shorted out there and was the problem for me. I just spliced the wire to bypass the connector and they worked for me fine. Might help, might not... but worth a look see. Cheers