Recent content by ross

i suggested a cheap brand because he said it would be in stop and go traffic

ok i just checked and there are clips with the 40 series, 50 series, and a borla catback that you can listen to

i havent looked in a while but at www.exhaustsoundclips.com then have sound clips of a lot of cars and a 4.0 might have a clip on there. as far as flowmaster goes 40 series are the loudest, then followed the 50 series. i wouldnt waste your money on some name brand muffler when you can get one...

Will it fit without an adapter

because with a 4.0 stroker i would have to do a 4.0 swap ;). and if you think a 4.x stroker is easier on the wallet you havent done your homework

yes i have covered most of this. rear end will be an 8.8 with 31 spline output shafts, with the front having a locker and 31 splines also. i have a mig and a tig at my house so i can fab up exhaust no problem. any fullsize truck radiator will work but i will make the mounts also out of steel...

i would also help to know that it will see limited if any street use so reliability isnt an issue at all

ok in the next few weeks i am going to buy an engine for the motor swap into my jeep. i have been contemplating the idea of a 4.0 or a 350. i think i have decided to go with the 350 but wanted some advice from people with a bit of experience on this subject. i will be buying the motor, trans...

it will fit you will just have to drill/tap a hole and weld the bung up near the cat. if i were you i would have kept my money and gutted your stock cat unless you are having to deal with emissions

also will a 4.0 I-6 engine and tranny bolt to the stock t-case of the 2.8

what kind of power does the 3.4 lack as opposed to the 4.0. im in the middle of searching for an engine and trans for this kind of swap also. would i be disappointed by the gap in power after riding in a 4.0 on the trails for quite a while. also is it possible to swap a fuel injected 4.0 into...

just signed up here to get some help in the tech dept of my jeep. i was wondering what would be a good leaf spring with 4" to 6" of lift thats not very expensive. if you have a set and would sell and ship that would be great just let me know.