Recent content by rc10t4orange

Can you send a link to where to get a WJ swap and Currie setup? Unless you just get the WJ stuff from salvage?

Bad new camshaft sensor from Ebay(imagine that). I ended up buying a camshaft synchronizer w/cam position sensor from Rock Auto for $34. I felt that the shaft had some possible play in it so I went that route. Thanks for everyone's help!!

Changed cps, camshaft position, coil pack. Fuel pressure good. Best i can tell cps is producing voltage its supposed to. Did find the original camshaft sensor magnet was broken out of place when I changed it. Checked ground to body and engine. Not sure what to do next?

Didn't have much time last night. I plugged in the scanner and it said P0340 camshaft sensor. Now it's got me puzzled?

Meant to say "check CEL then check fuel pressure"

Thank you sir. Just got a code scanner at lunch. Used one several times but never had my own. Will definitely check CEL the fuel pressure. If I have no codes and fuel pressure probably just replace crank position sensor.

Heavyopp thanks for the help. You confirmed my thoughts. Sounds like we had the exact same symptoms.

Ok thanks. When it was running there were no service engine lights on. I know that doesn't mean anything though. Thanks for the input. I'll hook it up to a scanner tonight.

I assume it's npt just a regular code scanner you are talking about?

So my 01 XJ started acting kinda funny. Hiccuped and died a couple times restarted ok. Now all I get is cranking but it wont start. I can hear the fuel pump running and I made sure there was plenty of gas in it. I'm leaning towards crank or cam position sensor? Maybe coil pack? What would I...