Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
Yes I'm aware of that. I'm pretty sure I got the right one. When I thought I had it at top dead center, a couple of times it just sputtered then died. But if I put the gas petal to the floor it would run until I let off the gas.
Would I be right in thinking that, if aligned for TDC on the...
Ok, got my jeep to what I thought was TDC earlier, realigned the cam sensor unit and it started up. It idled just fine for about 10 minutes, when I got on the road, after not driving it for 2 months I was happy so I gave it wide open throttle, after about 10 seconds she died again and wouldn't...
Ok so I've been extremely busy and am just getting back to this now. I tested what I think was the right plug to test the crank sensor, i got between .3 and . 5 ohms. Bought a new crank sensor from Jeep, still no go. Can someone post a picture of the sensor I'm suppose to be testing to make sure...
Like I said previously, both sensors are swapped and the computer was reset and the code came back. I don't really wanna drop another 130 on a CPS unless I know it will fix it.
I'm not sure what damaged the old one. Externally it looked good but when I took it off all the internals were sitting on top of the oil pump assembly. I took care to clean them out without moving the half circle thing and anything else in there.
I don't think I have a synch sensor as I have a 2001 cherokee. I did replace the damaged camshaft position sensor. There's still a CEL after resetting the computer.
Well the 2nd new crank sensor didn't work. All the wires look good, its not any of the relays. Tried resetting the computer didn't change anything and CEL is still on. Checked all the fuses. Theres fuel in the rail, starting fluid didn't get get it to start. I'm trying to get a hold of a...
Thats what I thought too but it hasn't said NO BUS in a while and the crank sensor I put in didn't change anything.
When I took the cam sensor off today all the junk inside was broken, so that's clearly and issue. I put the new one on and it still won't start. Is it possible that both the...