Recent content by PopLockLSwap

I love the look of that front axle, very clean. Also did not know about Parts Mike so that's an option as well. I'd have to remount the sway bar mounts but that can be done as an after fact. I've talked with Casey from Cavfab and they do have a kit that would work for what I'm wanting to do...

Awesome thanks for the info! I know now there's tons of info and kits and 100 ways to get the job done and to be honest it's all almost overwhelming. I know the cavfab would be least expensive route, and it comes with heims, and SFR is also up there in price at a few hundred more but I believe...

Gearing up to do a WJ knuckle swap and trying to piece together what I need for everything to try to make it as smooth as I can. Currently the jeep has 4.5" lift with an IRO 3 link long arm kit. Jeep is an all rounder with daily driving and trails. She gets used for sure. I've got the knuckles...

Alright. It's been a minute but I've finally been able to get that Heater Treater door installed and I also did a cooling system flush. I also happen to change the blower motor resistor as I was right there. Heater door was an easy install. Instructions super simple, door was made of steel...

Alright, went and blocked those holes with some speed tape and what do ya know, air no longer is coming out of the defrost vents when i have the floor or dash vents selected. Defrost itself and Mixed vent works as should and I feel now everything is working as intended. For the blend door AC not...

So looking up more videos of people replacing heater cores has shown me that that door generally doesn't have holes in it. There's a pocket off to the side of it that allows air to also get through but that's more natural. I think what I'm going to do is use some speed tape to cover those holes...

I understand having the AC run for that but I don't quite understand why the holes are there if I select dash vents I'd want just dash vent air, not dash vent and some being deflected to defrost. That kinda takes away from the blowing power of the dash vents?

So I saw a YouTube video about a broken linkage not being able to mechanically move the door right. Pull the front radio plate off and remove the radio and as I'm looking at the linkage watching it move I look at the flapper door itself and it's got two holes in it. They look like they're...

I agree I believe the blend door is suspect just from how it's acting. For issue #1 I'll pull a vacuum on the line coming from the manifold thats for the HVAC system and see what it does as I change selection modes. Should the engine be off when I do this would that matter?

That's my thoughts as well tbh

So I've got a 2001 Cherokee. Been slowly fixing things as they come up and now I've encountered an issue that has me stumped. I can turn the HVAC controls to all the different positions and the air will be directed towards them no problem HOWEVER it doesn't matter if it's dash vent, or floor...