Recent content by paulsaddress5

Belltech 6400. That is about a 7 inch shackle. I have them in the rear of my truck. I know they say they lower a chevy, but that is because of the reverse shackle design. They are 2.5 inches wide so they will fit your leafs...

Thanks so much. One question, when you say front do you mean the right side of the picture?

Can some one please explain to me where each one of these lines goes? I'm in the middle of a 90 abs to non-abs swap. I got this proportioning valve from the wrecker, and I am redoing all the lines, didn't do it in the right order, and I have no idea where these lines go. From what i can see it...

!!!1 Yes i know. But i got a M/C and booster. Now with this crazyness of crap from that old system there, i can't figure out how this new proportioning valve. It looks like there is one inlet, and 4 outlets. Can someone explain where each one of the outlets is supposed to go. Like from the M/C...

ok so pre 1990. Thanks very much. I got it off via nuts under dash. So the pre 1990 mc and brake booster is simple? just 2 lines and a proportioning valve? I also need the proportioning valve correct?

k yes its not a 91. its a 90. Thanks for the help, but how do i get this MC off?

Yes that is exactly what it is. Can I do the swap on this system?? or is this system reliable if I change that "booster" unit?

I have what I thought was the crappy abs system, the "booster" or something is shot, so I was just going to replace it with the 96 or earlier non abs system. My problem is, I can't seem to find the booster, and I can't get a nut off. One of the nuts holding the master cylinder on is being...