• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by onupolarbear

  1. O

    231 transfer case output shaft differences

    Is there any difference between transfer case output shafts between 231 transfer cases? I know there are some diffrences between 231 cases (i.e. different length input gears and gear cuts) . . . I am trying to track down my BAD driveline vibes/shaking. Replaced my ruined 1994 XJ 231 transfer...
  2. O

    Vacuum switch to electronic switch on 231 TC

    It looked the same to me. I'll switch it out and try later.
  3. O

    231 TC parts

    231 TC parts from 94 XJ with 130K. Chain stretched and poked holes in rear of TC. I'm using the input shaft. All internals look good as far as I can tell. All other parts available.
  4. O

    Vacuum switch to electronic switch on 231 TC

    I am fitting a 231 from a YJ to my XJ. Can I replace the vacuum activated 4wd indicator switch fom the YJ's TC with my electronicially activated 4wd indicator switch? Is the diameter and thread of the hole the same?
  5. O

    BFG AT's 235/75/15

    Four 235/75/15 BFG AT's. Two have ~50% tread left (7-8/32). Two have ~30% tread left (5/32)- one of these tires has sidewall scuffing from curb rubbing. $50 for all four.
  6. O

    Trans Cooler

    I may be interested. How difficult is it to install? Shipping to 45840.
  7. O

    1993 Jeep Cheorkee and XJ parts

    PM on gas tank skid.
  8. O

    Parting Police XJ

    PM sent about vinyl floor.
  9. O

    C4x4 Front Tow Hooks FS

    PM sent.
  10. O

    Complete 98 XJ Partout

    Front driveshaft shipped to 45840.
  11. O

    New Tires, Help!

    The Trxus tires are notorious for being difficult to balance and out of round- just read some other jeep boards and you will hear similar complaints. I had a set of 31" Trxus on a Wrangler that I balanced numerous times but still not acceptable. I tried the blancing beads from...
  12. O

    Best source for aftermarket carpet?

    I'd be interested to hear your experience about the vinyl- installation, tips/tricks, durability, etc. I have considered it but didn't know anyone who has actually installed it and used it.
  13. O

    Front seat cover removal help

    Remove front seat from XJ floor boards via four bolts. Remove bottom seat cushion by four bolts holding cushion to seat frame. Unscrew six screws on side and two screws in front. Two of the screws in back will have a metal rod wrapped around them to help hold upholstery in. Remove metal rod...
  14. O

    Front seat cover removal help

    I am trying to remove my front seat covers to wash them on a 94 XJ. I have removed the seats and have gotten the bottom seat covers removed easily. Now I'm stumped on how to get the top seat covers removed from the seat back frame. :doh: I have removed all metal wires and retainers. How the heck...
  15. O

    Parting various XJ's

    Black piece. Thanks.
See more
Back
Top