Recent content by oilyjeep76

  1. O

    Engine swap

    I am replacing a bad motor in an 01 Cherokee. Can I replace with any year HO 4.0, or do I need to stick with 97+? Intake, header and accessories will be transferred to new motor. Thanks Theron
  2. O

    ZJ & XJ Front axles

    Is the Grand Cherokee and the Cherokee front axle a direct swap? Thanks Theron
  3. O

    2wd to 4wd conversion?

    prolly easiest to get trans & tcase together. should already be a hole in the hump for tcase selector to go. will need the plate out of a 4x4. there is also a linkage bracket that you'll need that goes on the underside left of the tunnel. Holes for it should be plugged with rubber bungs on...
  4. O

    Help

    Can anyone with a 95xj FSM please email or pm me. I need some electrical and pinout info. Thanks Theron Combs
  5. O

    231 linkage for 4wd swap

    Don't know about an MJ, but, I bought a 2wd XJ and it had the holes drilled on the hump for the linkage bracket. The holes were filled with little rubber grommets. Pull your carpet and look. There is probably a hole for the tcase shifter already cut out as well.
  6. O

    my homemade bumper build

    Newb ? since I'm not experienced enough to tell... Is that 2x4 and 2x2 tubing you are using? Thanks
  7. O

    Speedo gear $85!!!!!!!!!!

    Hello all. Regarding the speedo gears, I was under my 96 Dodge 2500 tonight fixing stuff and pulled the speedo gear in it. It looks like it is the same as the speedo gear and housing that came out of my 95 XJ. Not exactly sure on the housing (# of wires), but I'm about 97% sure on the gear...
  8. O

    Heater only works on 4?

    At napa, they cost right around $20. Just bought one a couple weeks ago.
  9. O

    AW4 to AX15 Swap info

    I don't think the 92 had a neutral or clutch switch. I could start that thing in gear and without clutch depressed. A handy little item when your clutch starts going out and you get stopped at a stop light (DAMHIK). Trying to use the factory connectors at wiring harness(speedo&4wd)on the 95...
  10. O

    AW4 to AX15 Swap info

    Hi guys. Don't know if this is the proper place to post this, but since you are in my area, thought I'd try here first. I am looking for some electrical scematics for a 95 and 92 cherokee. I am putting a 92 ax15 and 231 into a 95 that had an aw4 and was 2wd. specifically, I'm looking for...
  11. O

    VIN locations

    found another one on the front of the front frame crossmember. last 8 digits of VIN. I know that most frames do as well, but since there really is no 'frame' on the Cherokee, didn't know if there would be or not. I'm just trying to figure out how many places I have to grind that pesky ID...
  12. O

    VIN locations

    How many different areas is the VIN# on the Cherokee. I count at least 4, but didn't know if there were any more. 1. on dash, seen through windshield. 2. driver door information sticker 3. under hood, by left hinge on a plate. 4. on block Any others that you all can think of? Thanks Theron...
  13. O

    Herculiner interior in-progress... RUST INVASION!!

    I have found xylene at home depot in gallon jugs. That was about a year ago, but I know they sell the stuff by itself.
  14. O

    A Real Hybrid XJ

    I can't help you on the electric side of things, but for more info on diesels swaps, check out 4btswaps.com and dieseltruckresource.com There is another diesel swap site I used to frequent, but can't remember what it is now. 4bt site deals with the cummins 4bt ( baby sister to the 5.9 cummins...
  15. O

    trac bar adjustment

    I'm no expert, but have been thinking about this as well. I think you could get your tires perfectly straight, run a level up the outside of the tire and measure to the fender flare, or the fender, on each side. That is probably how I will attempt once I get my lift on, unless someone else has...
Back
Top