Recent content by mtl3314

there are no skid plates on the bottom of my jeep currently, the exhaust is secure, its definitely something bigger and definitely at least a foot below hood level.

everything in the dana 30 is bad, it ran dry when the seals went in the middle of a 1200 mile trip and i didnt realize until it was too late, i removed everything connected to it though so its just bolted in place until i take the passenger side apart to rebuild the entire axle. it is possible...

bump

rims are stock no hubcaps, i will definitely check the shocks, though i replaced them with skyjacker units about 15000 miles ago. the shock mounts might be worn, i just checked the top mounts but must still check the bottom ones as well as remove the swaybar, i don't think the swaybar can make...

its not the tie rod ends or the ball joints i checked them, also the noise doesn't sound like those it sounds like something heavy is loosely secured and bouncing around only there is nothing hanging and everythings where it should be and the thing drives like a dream. perfect example, it...

my jeep: 1990 xj 4.0 automatic np231, dana 30 with universal joints, not cv other tan the noise it drives fine I originally posted this: http://www.naxja.org/forum/showthread.php?t=1015098 I have a horrible clanging shutter that emanates from my front end whenever i go over any slight...

my jeep: 1990 xj 4.0 automatic np231, dana 30 with universal joints, not cv 4x4 is annoying vacuum actuated 2 piece inner passenger axle shaft system other than the noise it drives fine I originally posted this: http://www.naxja.org/forum/showthread.php?t=1015098 I have a horrible clanging...

thanks for the info to those who posted, while saving for a new axle ill prob remove the inner shafts of the old one, i think i might even drive it like that till i can get something like a super 30 kit or an lsd or something. the help is most appreciated.

hello all, i have a '90 6cyl laredo np231 automatic, i have had front driveline noise for about 3000 miles. i was narrowing down causes, replaced worn motor mounts and trans mount, u joints, all control arm bushings, anyway all this took a while and it turned out to be a failed diff seal, it...

thanks dave in eugene but sadly i have arms like treetrunks

thanks for the help, judjing on the landing that makes a good amount of sense

90 xj laredo, i searched first it snowed today and while driving i slid off of the road and got stuck on a cement barricade but i didnt hit the barricade more landed on top of it it mashed my bumper out of true and basically took out the bottom six inches of bumper and quarter pannel in...