Recent content by Mopar It

I got an xj front ds

need to replace my motor mounts and the oil filter connector deal is in the way of the bolts trajectory. how do i get this thing off? 89' 4.0L

alright so i should loosen the top radiator hose from the thermostat and fill the overflow bottle, cap it off, and let my jeep overheat until what?

here is a pic of my setup i have a draincock on my thermostat i got a housing off a 92' and it had a sensor so i put a draincock instead to bleed out the air but when i start the jeep with the bottle full of water i dont get any water coming out of the draincock even after reaching 210 degree's...

I think so. Could u run the procedure by me?

so I replaced my water pump in my 89 6 cyl and replaced the thermostat upon reinstallstion and now when I start it n leave it idling the overflow bottle starts boiling the water n I get up around 220 degrees so why is my thermostat not opening and having that water dump into the radiator like it...

no im just interested in how to line my doors up perfect for the time being. i unbolted from the body and left the whole hinge on the door for about a week a few months ago then put my doors on and their flare out near the bottom and dont secure tight so i get wind noise

i didnt cut them i just unbolted them completely. now i wanna put them back on correctly so i can cut them and add quick release pins

is there a surfire way to allign my doors 100% like OEM? possibly new mounts from a donor jeep? (ive took my doors off and thats when it screwed up my allignment when i put em back. also what can replace the stupid torx bolts?

yes tension on the belt and do i need to loosen the screw holding the jack screw in place? near the bottom or no?

any pic of how to adjust this on an 89 4.0?

I need a pic of the ps pump and how to use it as a tensionsr my adjusting screw doesn't work it seems and I'm still kinda lost if I used the right bolts In each hole

ok well I have two bolts left and I'm confused on which go where so I think I may pull all the bolts out and restart :(

Okay so i did everything but im left with 2 bolts that i gotta mess with. one is long and thin the other is short and thicker. here are the 2 remaining holes that they dont rele fit in, maybe someone can direct me from here. there are the 2 bolts i found and the holes that i need to...

Could u post a pic cause I can not find these bolts to save my life