• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by mknack

  1. M

    Dana 30 control arm mounts

    I spoke with one of the local welding shops and they were able to get some new lowers and repaired the upper and reinforced it. The job they did looks pretty good, I don't think I will have the same issue again. Thanks for help!!!!
  2. M

    Dana 30 control arm mounts

    Well, I crawled underneath my 2000 XJ today to try and find the source of a clunking sound and found out that pretty much all of the control arm mounts are cracked. The pass side upper is almost completely serparated and the lower pass side is all the way through on one side. After looking...
  3. M

    New Issues, cant figure out.

    Thanks for the replies. I will check and see if the upstream sensors are working properly. I know its getting up to temp, at least the gauge says so. Not having any hesitation issues, so Im guessing the fuel pump and filter are fine. I have around 135,000 miles on it right now, so I guess a...
  4. M

    New Issues, cant figure out.

    Hello, lately I have been running into a few issues with my 2000 Cherokee, 4d, 4wd. I am running a 6.5 in long arm, 4.11's and 33/12.5's. I used to average around 15 mpg overall, but that has changed. Over the last year, it has steadily dropped to about 9 mpg, and thats at best. Im not sure...
  5. M

    Sound System

    Thanks for al the replies! I will definitely check out the crutchfield website. I am trying to save a little money, but customer service is always a plus to spend a little more. I am not trying to go overboard, but I really would like a nice system that sounds great. I have the Sony Xplod...
  6. M

    Sound System

    I am looking to replace my stereo and speakers out of my 2000 xj. I would like to get a stereo unit that I can plug my ipod/iphone into and control it from the deck. I would also like it to be possibly satellite capable and be of high quality. I know that there are so many choices out there...
  7. M

    Blower motor install

    Well, I took cruiser and matthew's advice and checked the power to the blower. I bought a $12 multimeter from walmart and gave it a shot. When I went to disconnect the power cable, I noticed that it was pretty hard to disconnect it. Once I was able to get it off, I checked and it had 13.83V...
  8. M

    Blower motor install

    Ok I will check that. Thanks
  9. M

    Blower motor install

    I will see if I can find a cheap multimeter and check the power from the plug. Do you know what it should be reading at the plug with the switch turned on?
  10. M

    Blower motor install

    The blower motor on my 2000 XJ went out recently (I think). It just stopped working completely one nice hot day in California. I replaced the relay and the resistor with no luck. So, narrowing it down, I assume that its probably the blower motor gone bad. With that said, the dealer (Satan)...
  11. M

    Confer rack mounts

    Those look almost identical. I will have to check the specs on them and make sure there are no height differences. Thanks!!!
  12. M

    Confer rack mounts

    Does anyone know where if there is any place that still sells the Confer heavy duty roof rack mounts? I have the rain gutter mounts for my rack and three of the six have cracked. I guess they could be repaired, but I would like to replace them if I could. I checked around, and I can't seem to...
  13. M

    Transmission valve cable

    I think so, I have been checking my service manual and it says that the pan has to be dropped. I have been trying to find a writeup on naxja, but I cant seem to find it.
  14. M

    Moog rod ends

    Thanks for all the help. I ordered the Moog ones off the interenet and they should be here by the end of the week. I also ordered the same ones from Napa that I did last time. I hope I get a little more life out of them this time. I'm gonna throw them on this weekend and then get it aligned...
  15. M

    Transmission valve cable

    Thanks for all the help. I found one and I'm going to try and install it this weekend.
Back
Top