Recent content by mickyfinn

Personally, I would ignore it too and told her so... Anyway, she's got it back and off to force it down his throat. Let's just say she's determined! :) I have a feeling though, this won't be the last of see of it! Thanks again for all the input!

Hopefully the final update on a laundry list of problems... After cutting out the jumper, no more tranny codes! The stalling issue came from two different problems. The first I found early, the bad wire to the stator. This last issue was not the crank sensor (although, I changed it to hedge...

Thanks guys, I'll try and get to checking that crank sensor connection today and start another thread if some searching doesn't turn up anything that helps!

Update~ CEL has stayed off through an afternoon of errand running and codes stayed clear. I think I've seen the end of the tranny code issue. BUT... it started stalling again after driving around for a while. It hiccupped once as I turned a corner, then I parked it for an hour or so. When...

Update~ CEL has stayed off through an afternoon of errand running and codes stayed clear. I think I've seen the end of the tranny code issue. BUT... it started stalling again after driving around for a while. It hiccupped once as I turned a corner, then I parked it for an hour or so. When I...

Update~ CEL has stayed off through an afternoon of errand running and codes stayed clear. I think I've seen the end of the tranny code issue. BUT... it started stalling again after driving around for a while. It hiccupped once as I turned a corner, then I parked it for an hour or so. When I...

Lawsoncl gets the prize! Cut the jumper wire and it now starts as it should. I cleared the codes and so far it's been through a few starts without coming on. Here's what I'm thinking~ the car did not always start in every gear since we got it back with the new NSS and TCM. The connection of...

Hey guys, interesting take on the NSS bypass. I'll try taking that jumper out and see what happens. I'll also check the starter relay but I'll need a tutoring there. Where is the starter relay located? And I'm guessing I'm testing the #30 socket to ground with the ohm meter. Right? Thanks!

Okay, finally got a chance to look at it. I removed the PCM and inspected terminals and connectors, didn't look too bad. There was someones old splice off one of the grounds in one of the connectors which was spliced into another ground wire from the harness which led to a ground screw on the...

I think I read the same thread too and a few other similar ones over the last few weeks. I was too busy to get to the jeep yesterday, but I should have some time to dig into it today. By the looks of it, people have been looking for electrical problems in this car for some time. All of the...

Back in town and hopefully getting some time on the jeep today. I'm going to start by pulling the NSS and checking it out. It is brand new, but I didn't install it so who knows? Thanks yetimotronic, I'll try the reverse light method for adjusting afterwards. Thanks too Joe, I'll test the TPS...

No chance to get to the jeep today and I'm gone over the weekend. I'll update what I found next week. Thanks for all the help so far!

This just keeps getting better! Driving home late last night, motor just drops right off and stalls. I get it started again in neutral while coasting, then a minute later is does it again and won't restart in neutral. I throw it in park, and it starts right up again. Maybe coincidence...

Hey, quick question about testing the TPS. I'm assuming it's the sensor on the back side of the throttle body coming off the throttle plate (different from photos I found online) with a white connector. Could someone tell me which terminal is the ground, 5v power and variable? Thanks!

I matched the numbers on the TCU and it is the correct 386AA. I'm going to check the connector and add some dialectric grease. The girlfriend talked to him about getting the old parts back (he's a family friend which is how it ended up there in the first place~ and I'm not allowed to talk to...