Recent content by luskiiimj

I've got bpe's for the front lower and rear upper mounts. They are the Rocky Road ones. I'm thinking about getting some bilstein 5100s but I'm not sure which ones to get. The RR bpes lose me about an inch or two in compression, but I get some of that back with about a two inch lift. I also...

In spite of alot of the opinions here, I ordered the RR BPE's. 2 front lower, and 2 rear upper for $22 plus shipping. Pretty good deal to me. The install went pretty good, a little problem getting the old bar pin out and getting the new metal sleeve in, but it worked eventually. I'm very...

Looks like the temp problem fixed itself! Yay

So am I in the same boat? Here's mine. It's not really leaking that much. In fact, I haven't had to add oil between changes. Should this be high priority to get fixed, or could I wait a bit and go ahead with my BPE plans? Hope that worked

I took a quick look. I don't see anything getting fried, but I haven't checked the voltage. Where are the temp sensors? I think there are two. Maybe I could check or replace them?

Thanks, I'll see if I can check the voltage. If you get a chance, could you tell me a little more specifically about how to do it? I'm pretty new with electrical stuff. Also, the 98 does have a distributor. When you say the wire may be cooking somewhere on the rear of the exhaust, do you...

Hi guys, My first thread so don't kill me. I've got a 98 4.0. It was hesitating and backfiring through the intake on hot or cold start up for about 2 minutes, then it would run fine. Searched and searched but couldn't really find a consensus on what the problem was. I decided to replace the...